Best Settings on my 2k1 LCD

[Rowdy6789]

2k1 LCD
Dynaflow 68/45

what should the dwell and mrof be ?

[WarpedKid02]

Leave your Dwell at 14. For MROF, what is your ROF, and what hopper are you using?

[Rowdy6789]

um im using a Evlution 2 and my rof is about 11 bps but i think the setting on my mrof is like 13 or something like that

[Jedrith]

Then you are fine...the egg is suppose to feed at 17, but doesn't really. Its more like 15. You could set it to that if you'd like. But if you don't shoot more than 11 you can leave it at 13.

[DYE_Phreak]

I use dwell at 13 and MROF at 20 with the Halo B.

[Rowdy6789]

Is it true that if you put a higher MROF it will be easier to shoot faster?


Something I jsut heard, and was wondering if it was true

[Jedrith]

Nah...you are only going to shoot how many times the microswitch switches.

[shaneOK]

my mrof is 14 and dwell is 16

[TheKid_15]

Dwell is 14 and MROF is 18 with an egg2. I can do about 13bps on a good day and 12 on a normal day.

[bullseye2]

mine is on 10 dwell and mrof is 16. this thing ripps hardcore.

[smartLCD]

Can u guys go into a lil more detail to explain the Dwell, and the MROF and how they affect each other... thnxs

[Sebastian]

Originally posted by Jedrith
Nah...you are only going to shoot how many times the microswitch switches.


If your M.R.O.F is set to low... The Board will not register those trigger pulls above the set number. If it is set at 12 and you pull 15.....it will only shoot 12!! If you set it at 17 and pull 15.. it will shoot 15. Lowering the Dwell will increase the response time of the Hammer. It will cycle faster. Holding the valve open for a shorter period of time. Thus enabling a posible higher rate of fire.

I was only shooting 9-10 bps with a dwell of 13 and MROF of 14.
I switched it to a dwell of 10 and a MROF of 19 and I now do 15-16 BPS...easy.. with 2 lil pushes of a button....!! :) :) :)

[Clothier87]

but if your dwell is set too low, you wont get a stable and consistant air flow to the valve. and also, leave the MROF set 16 or 17. if you set it at 19-20 you have a higher risk of blowing out the solenoid, ram assembely, and your battery runs out faster. I have the dwell at 14 and MROF at 15(i can pul only like 12 oe 13 bps anyway, so it wont matter.) but when setting the MROF, make it like 2 bps faster than you can pull regularly, that way you have smaller chance of being capped off in high rates of fire. good luck.

[Sebastian]

If the valve supplies air at a dwell of 14... it can supply it at the same Stabilty and consistentcy at a Dwell of 12 or 10...the valve always works the same... it is just held open for a shorter period of time.........