Charging problem

[mbx1105]

I've only charged my battery once since I got my angel. I used the stock charger with a Radio Shack wall adapter (13.5v 1A) and it worked fine. I just tried to recharge it but it wouldn't charge. I followed the instructions but the screen would still show Tab in. I turned on the switch then plugged in the charger, i also tried it in reverse order. I pulled out the charger connector from the marker and after a few seconds the LCD went from tab in to safe. I plugged the charger back in and the bars started moving like they were charging. But when I took it off the charger it still acted as if there was no charge. Thats when I pulled out the volt meter. The battery had 4.8 volts but the charger had an output of 17 VOLTS! I traced it back to the wall adapter, that's the last time I buy anything from radio shack! Could this overvoltage cause significant damage to the board? If so can it be fixed?

[angel2k3boy]

I use a radio shackwall adapter at 13.5 volts and it's fine

[Big_Burn]

ya its fine the battry does that you have to put the gun in safe then plug in the charger...after you let it charge iv you pull the charger out earll it will go into battery analisis mode and isolate for abiut 10 sec then stop...hope this helps

Big Burn