Angel One pressure tools

[sipple31]

Does anyone have instructions on how to make the gauges for the angel one? I think there's two... the LPR and the Exhaust.

sorry if this has already been talked about... I tried searching! :bananahuge:

thanks

[GOD jr.]

Can't make them unless you have and can run a good accurate metal lathe plus have another set to copy. It's not the gauges themselves that are hard to get, it's the peices that connect them to your gun that you need.

[Shibbykins]

for the LPR get a Kapp volly drill and tap the flat end and screw in the guage

[pittbull01231]

I found the parts to make them! Where I work we use a lot of hard to find specialty type fittings and such. I was tring to make some and I found some they just didnt have the o-rings on the end of them. "you would have to put thread tape around the ends for them to work" Anyways long story short its a whole lot cheaper to buy the tools already made. I saw the price of the fittings and after you bought them and shipped them and got the guages and fitted them you could almost have two sets from FMA.

[Shibbykins]

link to fittings

[pittbull01231]

I dont have a link for them. I found these in one of our parts bins and pulled them up in or parts directory. Ill see if i cant find a link.

[sipple31]

IC IC.... so for starters, the LPR gauge is more important than the other, correct? I would probably buy one at a time for $ reasons.

[pittbull01231]

Well they are both just as important but if you had to get just one at a time then yeah i think i would go with a LPR guage.

[sipple31]

yeah... thanks man. I will end up with both by the end of the summer i'm sure... but I know that I will need them for re-adjusting when I get my magno kit... HOPEFULLY SOON!!!

:-)