cleaning guide

[SpaceGhost]

does anyone have a guide of what to clean on your a1 every time you play.. every few times... etc.
, thanks

[pittbull01231]

does anyone have a guide of what to clean on your a1 every time you play.. every few times... etc.
, thanks

Same as the older angels! Every 2000 shots place a couple drops of oil in the ASA and in the valve through the breach. Every 8000 lube it up, replace lcotie as needed. replace parts and seals as needed. I also recomend replacing at lest the valve and ram o-rings every 8000 regardless. a guide of what parts to lube can be found here: http://www.wdp.tv/e_blast07/140507-news/grease-lube.pdf

[sipple31]

Same as the older angels! Every 2000 shots place a couple drops of oil in the ASA and in the valve through the breach. Every 8000 lube it up, replace lcotie as needed. replace parts and seals as needed. I also recomend replacing at lest the valve and ram o-rings every 8000 regardless. a guide of what parts to lube can be found here: http://www.wdp.tv/e_blast07/140507-news/grease-lube.pdf

really? I would hope I get more than 4 cases out of my ram o-rings...

[pittbull01231]

really? I would hope I get more than 4 cases out of my ram o-rings... thats not APS recomendation on the o-rings. thats just what I advise. If you strip your marker down alot the I would for sure. I only recommend that because the simple fact that just becasue an o-ring looks good dosent mean it is. I have had some problems not just in paint guns where an o-rings was leaking but it looked perfectly ok. And if you get any oil like WD-40 on them then it tends to degrade.

[sipple31]

gotcha gotcha... that makes sense.