RAM/leak question

[sipple31]

I have a leak when I air up my A1... but when I fire the gun a few times it lessens or sometimes stops. After some research i've learned that my RAM might be too worn out?
I see that you can buy the newer one here: http://www.angelpaintballsports.com/product.aspx?guid=691467f5-4f77-4455-89d4-9b4da15f990e
but it says to be used with Magno Valve... where do I get that?

thanks!
-Luke

[xmc1146]

I have a leak when I air up my A1... but when I fire the gun a few times it lessens or sometimes stops. After some research i've learned that my RAM might be too worn out?
I see that you can buy the newer one here: http://www.angelpaintballsports.com/product.aspx?guid=691467f5-4f77-4455-89d4-9b4da15f990e
but it says to be used with Magno Valve... where do I get that?

thanks!
-Luke
you have to wait till its available at fixmyangel.com or talk to bob using that sites #.

[onasilverbike]

I have a leak when I air up my A1... but when I fire the gun a few times it lessens or sometimes stops. After some research i've learned that my RAM might be too worn out?
I see that you can buy the newer one here: http://www.angelpaintballsports.com/product.aspx?guid=691467f5-4f77-4455-89d4-9b4da15f990e
but it says to be used with Magno Valve... where do I get that?

thanks!
-Luke

Often due to dirt/used lube around the ram shaft o-ring, cleaning it often does the job, or replacing the o-ring if its bad, you should be able to see the wear on your shaft if it is bad enough to cause a leak when the o-ring is good.

[pittbull01231]

I was told by FMA. I also have the same problem! that the inside O-ring is bad and the ram has to be replaced. The ram you are looking at is the magno. go to www.fixmyangel.com and order a ram. unless you want to wait for tha magno ram.

[sipple31]

hmmm after tearing it apart, cleaning, lubing... I did a bit more testing and I guess the leak is coming from the connection between the reg and the gun. Does that mean that the goofy shaped seal in there is bad?

thanks

[pittbull01231]

you can just try to tighten it up or put some lube on the seal

[sipple31]

wow nice I actually flipped the seal because it didn't look right... lubed it and it worked! No leak at all.

thanks for the help... I think I still want to get my hands on the Magno RAM/valve.

[pittbull01231]

Who Dosent!!!!!!!! Me Need Magno! Me Need Fly!