Trigger problem

[Rob G]

I just got a Lasoya trigger for my lcd and I am having problems. It is acting like the trigger is pushed down while in safe mode( just showing serial number). I adjusted both screws and I can get it to work for awhile but it will go back to just showing the serial number. Looking at the board I noticed that the switch sits at an angel and think that is what is causing the problem. anyone else had this problem?....or maybe have a solution.

[dr.strangelove]

Sounds like the bottom trigger screw is out too far and pushing against the microswitch. Back it out a little bit, and adjust the top screw to shorten your trigger pull, that might be it. It could also be that your board isn't mounted properly?

[TheVince]

Yeah I agree. turn on the LCD and back off the bottom screw until it releases the microswitch then turn it back in a bit, then adjust the back travel with the front set screw.

[tomrs15]

the switch is not supposed to lay flat. its supposed to be on a angle. try backing out the 1 screw like the others said