led battery on a lcd

[wonkaa]

what do i have to do to my charger to be able to charge a led battery with a lcd charger (off a 2k2 fly). also one of my bolts is stripped the one closest to the trigger anyone know any easy safe ways to take it out?

[dr.strangelove]

The LCD charger is not compatible with the LED. The LCD charging is controlled by the board, where the LED charging is controlled by the charger. So the chargers are very different.

As to the stripped screw, you can try epoxying a hex key into the stripped head, letting it dry, then turning it out. If that doesn't work you can try slotting the head with a dremel or hack saw blad and remove it with a flat head screwdriver, or buy an easy-out from your local hardware place.

[Shibbykins]

i use the dremmel method personally cuz hardware stores are a bit hard to come by in korea lol.

if its in a tight spot like the grip frame i usually break down one of the dremmel "blades" and round it off so its 1/2 to a 1/4 the original size and go at it. takes a steady hand tho

i beleive the MT's can take care of a stripped screw if your unable to. id check there websites also

[tom allen]

If it's the hex in the head of the bolt that's worn, i've always used a centre punch to remove these screws. First you make a dot on the head towards the outer edge, then use the punch at an angle and drive the head anti clockwise. You dont need a lot of force as the light shock from the punch breaks the grip of the screw.

[tom allen]

Wonkaa, are you trying to charge the battery in al led, or an led battery fitted in an lcd.?

[wonkaa]

aight thx alot that all helped, and my battery on my lcd isnt working properly so i was gonna swap it with a led battery but i wasnt sure if i would be able to charge it with my lcd charger which i cant so i wont be doin that
again thx for all the help