Problems...plz help

[dude_1999_ca]

i just adjusted my trigger and now when i turn on my angel it doesnt go into safe. plz help. also which is the screw which makes the trigger pull lighter?

[Emmit]

is it stuck on the serial number? If so it means you over adjusted the trigger, you'll need to give it a little slack, the screw under the spring is the one you want to adjust

[SkeL]

Making the trigger "lighter" has nothing to do with screws. You can interchange springs to adjust that. When I had my lcd, my favorite setting was, any touch to the trigger and you would activate the switch, and I had no spring. It's not too good for the switch, but I never had any problems. If your problem is what emmit stated, he gave the correct fix. Let us know how it turns out.

[dude_1999_ca]

thanks guys it works fine now. Also what exactly do the two screws change? i read the manual, messed around with them and they seemed not to change much. Thanks for the help

[Emmit]

the screw under the spring changes your activation point of the firing, the other screw is your over travel screw and adjust how much play there is in the trigger after it fires...