My G7 eyes don't work with my angry M7 board

[PaintballJunkie66]

I just receivedmy new M7 board this morning. When I first installed it the eyes turned on and worked properly. I fished through the manual for the modes and changed it to unlimited ramping, and from there on out the eyes didn't work. Even when I changed the mode back to semi-auto they ceased to function. I've owned my G7 for just short of a year now, but it hasn't seen a ton of use. The stock board reflects just over 16,000 shots so I know it's not worn out. I bought the board friday and took it out of the package this morning. So I'm rather confused.

[for2nato]

thats typical. the tadao boards usually need a fresh set of eyes installed to work properly. i actually went through 3 sets on a marker i set up for my bro before they would work.

[Mavrick]

Try putting the stock board back in and trying the eyes on that one. If they work fine then you know if what for2nato says has bite to it. I have seen that myself but sometimes if you very carefully reflow the solder on the diodes that can help.

[PaintballJunkie66]

I put the stock Fly board back into it, bu tthe eyes didn't turn on. Then later after i had put the M7 back into it they started working again. Then, not thirty seconds later, they became very dim, and they've now stopped working ever since. No matter which board is in it.

[Rockbert]

perhaps the info here might help the eye problem...

http://www.angelowners.com/showthread.php?t=64296

or this one...

http://www.angelowners.com/showthread.php?t=63361



Good Luck