A4 Fly JD Feedneck O-rings

[K@iman]

Apart from buying a new feedneck, is htere any other home mod etc. that I could do to ensure my eggy doesn't pop out in a slide? It's happened before and I am scared it will happen again.

I have used all the orings and swapped them out to check for a tighter fit. Can anyone tell me what is the best size oring for a eggy loader?

I have also tried insulation tape (Black) but that makes it worse and the orings slip off the tape and just pops out even quicker.

Also when I jiggle my marker the loaders turns so that it is facing slightly to the side. In a game it will get so bad it will turn all the way around. And the feedneck can't tighten anymore?
I don't want to spend more money on the marker. And really need some tips or can I say....cheap tricks.

[WDP ir3 2k3]

What you want to do is. Take the o rings out of your low rise. Put the O rings on the feed neck on your egg. Then put the hopper back on the low rise. tell me if that works for you that what I do.

[BoB]

Have you considered trying the new one piece insert which replaced the individual oring setup?