Low rise

[PhxHavoc]

How do i get the high rise out to gewt my new low rise in and when sanding down my eggo II do i sand itdoiwn to make it shorter or do i sand down the neck to make it thinner

[MooShoo1717]

I dont know how to get the high rise out. (My first angel is on the way.) But i do know that you sand the egg 2 to make it thinner because it wont fit in other wise. They length will be just fine unless you want the Egg 2 to be lower. You might be able to make it shorter by sawing off the end but im not sure.

[Ir3Flyer19]

the low rise might be tough to get out since i believe its locktited in. you have to be careful not to strip the threads also. if you dont care what happens to the old low rise you can use a vice grip but that will scratch it up a lot. Otherwise you will need a rubber locking channel grips so you can get a good grip and leverage or something similiar. Maybe wrap something around the lowrise and put a vicegrip over it. THere are probably better ways that I dont know of.

[jasyn]

first off .. which lowrise did you purchase?

2nd ... do NOT sand down the neck of the egg2 until you have your lowrise in hand to test fitment.