PDA

View Full Version : Opto and factory trigger problem

DamageLn
03-22-2007, 07:46 PM
Alright I was following manual instructions while greasing up my gun, when I ran into an unexpected problem... 2 actually.

The trigger came out from the board and im staring at a metal spring/tab and cannot figure out how it seats in the board... And the gun when turned on keeps making a buzz noise, that it usually makes when turned on then shuts off, it just stays on though now.
for2nato
03-22-2007, 09:24 PM
it is normal for the screen to make some noise. it is from the lighting system.
is the spring tab still attached to the trigger? if all is still intact then you should be able to just swing the trigger back into place and the tab should slip into the optic slot. if you shine a light into the front of the board you will see how the trigger goes in.
DamageLn
03-22-2007, 09:29 PM
Yeah the tab is still attachecd to the trigger. As for the lighting noise, usually it will stop, its like it keeps reseting itself or something.
for2nato
03-22-2007, 09:59 PM
you can turn the light off to stop the noise if you wanted.
josh_hill
03-23-2007, 02:39 AM
The trigger came out from the board and im staring at a metal spring/tab and cannot figure out how it seats in the board...

Sometimes that "silver tab" (the leaf) is a little higher than the opto switch...get a flashlight like for2nato said and you should be able to see where it slides into the opto switch. You may need a small screw driver or something to press the leaf downward just enough to get it into the switch.
DamageLn
03-23-2007, 07:10 AM
Thanks for the replies everyone, I think I have it properly seated in the board, I wont know till I get home from work. It was late and I couldnt run air through it, heh i would have woke everyone up here at home :D The trigger was clicking with the eyes off, so hopefully im good to go
DamageLn
03-23-2007, 06:34 PM
Well I came home from work today, gassed up the gun, through some balls in it and she works. I have to admit it was kind of a PITA to fit the trigger in there. But yeah I loaded up a hoppers worth of balls and unloaded them on a nearby tree. Thanks for the replies on this one guys

~Wayde