Is it possible to intellifeed a halo b?

[andronikos916]

Is it possible to intellify a halo b? ...the reason I am asking this is cause I've heard that sometimes that a ball past the detent on the Angels (not speed, lol) and causes chops...not tested thought...


...just wondering cause I am thinking of ordering one...


...thanx:evilgrin:

[Jedrith]

Its a good question, If you knew the voltage on the halo and the angel, I could tell you.

[Emmit]

I think the guys at Odyessey say no, but what do I know? :dunno:

[warpedx]

6 AA's in a Halo x 1.5V is 9V. I think an Angel is 4.5 at the intellifeed. If you could wire in a gating circuit where the 6 AA's would pass power directly to the motor when the intellifeed voltage was present, you'd be in business. Hmmmm, pull the board out of the halo, get a switching circuit are a really fast relay, wire the leads of the batter pack to the motor, with the Relay/Switch in series with the positive lead, and voila! IntelliHalo.
Just gotta play with you intellifeed settins so that it doesn't spin too much. 4 balls fed per trigger pull = a mess in the breech and barrel.

[jasyn]

just get the TE updated halob and you shouldnt have any problems with forcefeeds.

[captncrunch]

but if you tuly intellifed the the halo(halo uses guns battery) the halo drains really really fast, some guy tried it, forget where i heard of it.