help me with ir3 board upgrade

[demolition man]

i have had an ir3 for a while now sitting in my gear bag, i was planning on buying a new proto rail but instead i gave decided to dump the $400 into my ir3. i was wondering what you would thing some good upgrades i should consider. i am sending my pieces to grunt bull anodizing to get a new sick anodizing job. i have already purchased a new valve assembly( the old one was crap) abd a delrin hammer, dye drop, and a bob long torpedo reg, high rise clamping feed neck. i am currently using a reloader b, but i was wondering the best way i should go about getting a upgraded board and install eyes. i herd the speed boards are compatable. if i get one ,the eyes and wiring harness, is there a way i could install it in my ir3, a have access to a machine shop, i need to know how the eyes are acualty wired though the body and how they would run to the board. help would be greatly appreciated, thanks

[for2nato]

you would have to do it one of two ways. either buy a diverter plate kit for the sensi or reroute and plug the existing holes. once this is done you can route the wires for the eyes through the grip frame and up to the sides of the breech at the feedneck.