Halo B, fit???

[akes]

1st -- Just bought a used Halo B. Is there a Rise that will work on the Angel such that you dont have to sand down the neck??.

I heard that the DYE`s work ?

2nd -- I have 2 Angels I may want to use it on, so should I just sand it?, will sanding affect the Resale??

Thanks --------------------- Big Al

[jasyn]

i have a dye low rise and the fit is very snug. maybe even perfect. if not .. nothing a small strip of electrical tape cant easily fix.

sanding MAY affect resale depending on the buyer.

[akes]

I am going to try an adjustable feed before sanding, any thoughs on these??? ---------- Big Al

[jasyn]

most i've seen are far too fugly imo. so ugly that it outweighs the practical function it serves. :tongue:

why not pick up a dye rise? i played with mine today and everything worked just fine.

[crashdan]

the demonic strangler is a prefect match for the halo, it is a combo high/ low rise with am adjustable center to "strangle" your hopper so it does not move.. see www.roughneckpaintball.com for more info or pm me and i can get you info as well

[Emmit]

CCM makes a good clamping rise, bought one for a buddy at Cup to put on his BM to use the Halo......

[Gary1]

I sold the strangler that I had...it was too "busy"...too much to deal with...set screws, compression sleeve, lock collar...seemed like a good thing at the time. A good taper fit is hard to beat. Make sure you do a good job when sanding your hopper....

[SkeL]

55$ bucks for a strangler!?!? Good lord, I didn't know they were that much.

[akes]

Found one on E-bay, $25, cant go wrong, going to try

[Gary1]

Dude, that must be the new and improved model...looks alot better than the one I had!

[akes]

Dont think it`s a Strangler??, not sure who it`s made by. I will report on its Effectiveness -------- Big Al

[Gary1]

Does anyone know who makes it?