the_kwa
01-23-2007, 11:58 AM
Sorry for no pics. but some day I'll try and get some up..
I'll start off with the top of the frame between the frame and body.
go 0.651 in. back from the front of the frame. make sure your centered and drill a hole with a #31 drill (0.12 dia.) 0.3 in. deep.
you now, in the same location, need to make a hole 0.272in. in dia. about 0.063in. deep. (this is for the LED stock o-ring on top of the frame)
(you can adjust the sizes of the holes alittle, but the location is pretty important)
now for the front of the frame were the asa conects..
I went down 0.2645in. from the top of the frame, again centered. with the #31 drill, drill 0.687in. deep.
now you need to make a hole 0.367in. in dia. about 0.292in. deep. The dia. of this hole is important, if it's to big your asa will leak..
I would recomend a Machine of some sort to do this mod. Like I said, I'll try and get pics up some day.
Good luck, and it's not my fault if you mess up...
I'll start off with the top of the frame between the frame and body.
go 0.651 in. back from the front of the frame. make sure your centered and drill a hole with a #31 drill (0.12 dia.) 0.3 in. deep.
you now, in the same location, need to make a hole 0.272in. in dia. about 0.063in. deep. (this is for the LED stock o-ring on top of the frame)
(you can adjust the sizes of the holes alittle, but the location is pretty important)
now for the front of the frame were the asa conects..
I went down 0.2645in. from the top of the frame, again centered. with the #31 drill, drill 0.687in. deep.
now you need to make a hole 0.367in. in dia. about 0.292in. deep. The dia. of this hole is important, if it's to big your asa will leak..
I would recomend a Machine of some sort to do this mod. Like I said, I'll try and get pics up some day.
Good luck, and it's not my fault if you mess up...