Tadao my LED?

[vietangel]

Hey, i have been doing some research on the Tadao board and was wondering if i could fit it into my LED.
I read somewhere that the tadao board will only work if my gun has eyes? which the led does not...
is there any way to install the tadao board in my led??
Any tips on how to install it??
Does anyone have pics?


thanks in advance for any help!

[rammstein_5]

Yes there is a way. Not complete on full details and if i get a digital camera when i attempt it i may write up a manual on how to lcd your led.

Basically get an lcd frame and drill a few careful holes and a counter bore in the frame and install it on your led. It will let you use the lucky or any lcd boards available for angels.

You can then use tadao board or lucky with the tadao chip. Otherwise i do not know of any companies out with led aftermarket boards.

Im sure for any board it has a setting where you can turn eyes off and still use it.

[vietangel]

Hey, thanks for the help!

any ideas where i can purchase an lcd Frame?

i heard the eclipse trigger frames are not being made anymore..

[lipe33]

Here is a link to a guy here parting out his LCD. He might be able to help you.

http://www.angelowners.com/showthread.php?t=62937

[chris71383]

Unfortunatly you can't put an LCD frame on an LED, the air from the HP reg is routed thru the frame(the tube that runs from the reg into the front frame).

[vietangel]

so is there any way to install the tadao board in an led?
do i have to cut the led frame in order for it to fit?
or do i just need a different frame other than an lcd?

[Blister]

Unfortunatly you can't put an LCD frame on an LED, the air from the HP reg is routed thru the frame(the tube that runs from the reg into the front frame).

Yes you can, it just requires some work, and intelligence. I have done 4 successful LCD frame installs on LED's. If you have access to a drill press and a set of calipers it can be done quite easily.

[chris71383]

Ok, without access to the equipment and the experience to do it you can't just bolt up an LCD frame to an LED. **Fixed**

[rammstein_5]

Unfortunatly you can't put an LCD frame on an LED, the air from the HP reg is routed thru the frame(the tube that runs from the reg into the front frame).

Check out the_kwa thread. It was quite good. He is a very nice person willing to share exact measurments for a mill... unfortunetely i do not own a mill. Possibly if you have the cad files or just measurments it wouldnt take much for a machinest to do for a couple bucks if you knwo them, maybe not since its simple to them i supose.

or maybe find a machinest who endours paintball and would do it for a cost or free.

Overrall though it can be done for sure, just need to find someone who is a machinest.

[vietangel]

That sounds great... i was gettin worried for a minute that it couldn't be done.

Any idea where to locate this kwa thread? i did a search but nothing came up.

[rammstein_5]

http://angel-owners.com/showthread.php?t=63144

That is the thread.