Can you tell the mod?

[afortuna]

A4Fly with a Lucky Board and ...

http://img1.putfile.com/thumb/12/35400500963.jpg (http://www.putfile.com/pic.php?img=4304100)

What could that be used for?

[for2nato]

hey look, its my joy!!!

[crownsk8er]

is that a dye membrane pad?

[Brad7]

Yes, I believe it is but it seems like it would be rather difficult to connect it through the rail.

[for2nato]

you want pics of the inside? it is fully functional. i did it because i was never comfy with the way the buttons felt. you had to push hard. especially the eye button.
http://img1.putfile.com/thumb/12/35517485037.jpg (http://www.putfile.com/pic.php?img=4315470)
http://img1.putfile.com/thumb/12/35517485028.jpg (http://www.putfile.com/pic.php?img=4315471)
i also did this to prove that there is no mod necesarry to install the lucky into an 05 speed. you just need to solder 3 wires. and the button will mount on the speed better too i have a pic of where to put it on the frame of the speed.
http://img1.putfile.com/thumb/12/35517515561.jpg (http://www.putfile.com/pic.php?img=4315477)
if you put it under the trigger gaurde at the bottom its out of the way. and goes right into the grip.
if anyone wants the schematic just pm me.

[Engus]

could post up directions on how to do that, because i would love to have a membrane on my un1'd fly

[for2nato]

sure here you go. if you flip over the board and look at it as it is in my pick above. there are two sets of contact points. one for each button.looking at it as it is in the pic above. the contacts on the left of each set are the common. the contacts on the right are pos. solder a wire to each of the pos contacts and 1 to only the common of the power button. solder to pos wires to the outside contacts of the 3 pin pad adaptor. and the common wire to the middle conntact. plug it into the pad and your set.

[Engus]

and the buttons can still work right? i just wanna be sure that if i dont like it i can just cut off the wires and go back to the normal buttons. thanks for the info