G7 quits working???

[loonis]

This usually happens when it's cold out (50's). I can shoot a rope then stop, then try again and a ball rolls out the end of the barrel and it won't shoot for a while. I try to figure out whats wrong with it and it starts shooting again, so I think its fixed. Then the same thing happens again, shoot a rope then it quits.
Could my dwell cause this problem? I have it set at 9. I've tried both a lp and hp tank and it doesnt seem to matter. My gun acts as if it wasnt getting air or something.

Thanks

[RangerJoe]

wat are all you pressures?
check battery
check settings
clean eyes
check trigger adjustment

[NitroBall]

Is the screen still on when this happens ?
(If screen goes off, possible battery or connections)

Have you tried dry firing it, to see if it does the same thing ?
(If dry firing is ok, then possible eye problems)

Check these first , then post back.

[loonis]

settings:
mode 1
eye test= good
mrof 25
hopper sp 9
hopper T1.00
hopper A1
dwell 9
TR 2
lpr 55-60
reg. 300-350psi
the screen stays on and the battery is charged. I have about 33,000 cycles. Clean and lube (oil mostly and some grease on the parts that take grease) when needed (clean after every use). The trigger pull is about a half inch. When I tried dry fireing it, it sputtered for the first 20 or so shots then started shooting fine. I turned it off started shooting again and it was fine, then started sputtering again.

Thanks Nitro and Ranger.....

edit: I can hear it clicking with no air. Does anyone know the symptoms of the 14 way going bad? That's the only thing left that I can think of.....

Thanks culver....

[culver]

Almost sounds like your noid is having problems. Shot without air so u can hear the click. If it continues than your noid/wires/board have a problem. Good luck!

[RangerJoe]

try greasing your solinoid seals