Ram removal questions

[Bubbles]

Hi there. I have followed all the instructions on page 28 of the manual to remove the ram. I can't get the ram assembly to come out. Should i use pliers on the back to pull it out or is there an easier way.

Any help would be much appreciated.

[Russ A1]

Maybe a silly question but have you removed the ram lock pin, if you have and its the first time it's been out try puting the breach block release knob back on to give you a bit of grip and don't use pliers you should get it.

[Bubbles]

I have removed the pin and also have tried putting the knob back on. It is wedged in there pretty damn tight. Any other sugestions?

[Russ A1]

Have you tried to push it from the exhaust valve end?

[Trigga Nometry]

Just another silly question, you have removed the bolt, right? If you have, Russ is right, try removing the valve too and push it through from the valve side with a squeege.

[Bubbles]

I have removed the bolt! Now I can't get fore grip retaining screw out. I have Angel 1 pieces everywhere! I'm gonna get some good ball drivers at the weekend and have another go.

Cheers for all the advice so far! Im sure I will work it out eventualy!