Intellifeed problem

[Kill4Less]

Isnt an intellifeed supposed to run for the time I set it for on my board. I just installed one on my gun is it not working right? It just runs like a notmal halo. I was just useing it dry do I have to put paint in it or will it work just by pulling the trigger?

[Trigga Nometry]

The MT Intellifeed uses both the Halo eyes and the Intellifeed signal. If the Halo does not get an Intelifeed signal, it will revert to the eyes. So without paint, it will appear to work like a normal Halo. Once it sees paint, it goes into Intellifeed mode (as long as you have it plugged in and have the Intellifeed turn on what ever board you're using).

The best way to test it is to remove the Halo but still have it plugged into the Intellifeed connection and put your finger up the Halo's neck so that it thinks there is paint there (the drive cone will stop spinning). Then while you finger is there, pull the trigger (best to do this dry firing lol) and the cone will spin showing you that the Intellifeed is working.

[Kill4Less]

It wont do that for me. I have no cluse what could be wrong I though I set everything up right

[Kill4Less]

Do you have to turn it on in a g7. I have it set on A1 t=.1