breech block

[crownsk8er]

how do i get the rods that hold the breech in on the o5 speed? ive taken out the grubs

[warpedx]

If you have remopved the brub screws, al that will remain is a straight pin. Find something in a similar or smaller size to tap it out with. Be careful, but a little tapping of the hammer should get you a long way.

[crownsk8er]

u sure? cause i think its threaded

[warpedx]

Then what would be to point of the grub screws?
If you want to make yourslef feel better about it, look in either end of the pin for an allen fitting. When you don't see one, commence the beating with a mallet!

[crownsk8er]

i wasent saying you were wrong, i just wanted to be ceraint before i spart beating my gun with a hammer

[RangerJoe]

yea there sn allen key spot at each end..i took an allen wrench and aplliend force to one side and pulled gently at same itme..it came out.tehn you can clean all teh grit that gets in there.

[warpedx]

i wasent saying you were wrong, i just wanted to be ceraint before i spart beating my gun with a hammer
I hear ya, I was real cautious with my first angel. Guess I lost my fear of slipping and scratching it over the years.

[crownsk8er]

well its not my first angel, i can tech an lcd somethin fierce, but its my first speed, and i have never taken the breech out on the lcd anyway

[Devs]

the pins are threaded on the inside. I think is M3 but i'm not positive. And to get to them with something threaded, it needs to be pretty long. The Allen wrench trick has always worked wonders for me so give that a go.

[crownsk8er]

ok, i tried tapping it out with a allan that fits in the hole but not in the breech block pin, i tapped it with a hammer and it moved, but when the block got to the body it would stop, so i tried it the other way and it did the same thing what do i do

[crownsk8er]

i got it, and its a m2 screw, one out of the solonoid, well i wont be using it for a lil while anyway so i just have to get another screw cause i completely trashed it, and a new pivot pin,


to everyone that told me to tap it out, i have a mind to kill you, IT IS TWO PINS that YOU HAVE TO USE AN M2 SCREW ON, i have to buy a new pin cause you told me that it was one pin and now its a lil §§§§ed up

[warpedx]

Feel free to start the killing. I would have used a large hammer if it were my gun.

[Th3bLaCkNiGhT]

Feel free to start the killing. I would have used a large hammer if it were my gun.
are you serious? there are 2 pins holding the breach in. one on each side and you cannot go thru the breach. you must pull them out using a suitable screw (m2? m3? m7? idk but i have one) that you screw in and then pull out the rods.

[crownsk8er]

its an m2 josh