question about a4 and tadao board

[nomercyangel09]

is it neccesary to have eyes to use the tadao in my a4. if not, will the mrof of the board be affected if i don't use eyes.

[GMG Force Fly]

is it neccesary to have eyes to use the tadao in my a4. if not, will the mrof of the board be affected if i don't use eyes.

It is not neccesary to have the eyes. Youll have to turn them off and your MROF will limited to 20BPS.

[nomercyangel09]

i am not saying your wrong(because if i were i wouldn't be asking the question), but in a post about the speed 04(no eyes) and the tadao, a mastertech said you would have to set the mrof to match your loaders speed. that sounds like the mrof could be unlimited, right? wouldn't that be the same for the a4 too. any mastertech out there i can get some advice from.

[thatguy!]

With eyes off, the absolute maximum ROF is 20. That's it. End of story.

Maybe the other guy had an Egg, and the MT wanted him to set his MROF at 15 or something.

(But you do bring up an interesting point... I've never tried to set my eyes off MROF. I'm pretty sure you can do it, but I've never done it. Your eyes off MROF is capped at 20, though, no matter how you slice it. Read the manual. The manual does not lie.)

[nomercyangel09]

thanks for clearing that up. i hadn't really gone that deep into the manual. kinda skimmed over it is what i did. was really hoping it wouldn't be capped.

[dirtywyrm]

He said set the ROF to match your loader, meaning, if your ROF is set at 20bps, and your loader only feeds 15bps, your going to have problems and start chopping paint.

So you'd set your mrof to match how fast your loader feeds so you won't out shoot the loader.