GShoaf
03-25-2003, 07:51 PM
My cops worked on day and now it doesn't work....
OK i have looked at the cops thread under the tech reference. I did everything that it said.
I cleaned the rod and i cleaned the hole where it goes through the gun. and i filled the plasitc piece in the grip frame where the bulbus end of the rod goes with grease...and i lightly greased the black piece under the gun.. and i tried to keep everything else clean.. Ok, so i have a question about the clear plastic piece there are 2 gold/brass looking pieces in it...mine are not connected are the supposed to be? the wires apprear to be fine. they are not cut or anything. It will not pass the drop test. why would that be? any sugestions on what to do? did my cops just break or have i done something wrong...!?! and it's a red cuta and carved with a mem 4 board if that matters.
this is frustrating me.
thanks
Grant
OK i have looked at the cops thread under the tech reference. I did everything that it said.
I cleaned the rod and i cleaned the hole where it goes through the gun. and i filled the plasitc piece in the grip frame where the bulbus end of the rod goes with grease...and i lightly greased the black piece under the gun.. and i tried to keep everything else clean.. Ok, so i have a question about the clear plastic piece there are 2 gold/brass looking pieces in it...mine are not connected are the supposed to be? the wires apprear to be fine. they are not cut or anything. It will not pass the drop test. why would that be? any sugestions on what to do? did my cops just break or have i done something wrong...!?! and it's a red cuta and carved with a mem 4 board if that matters.
this is frustrating me.
thanks
Grant