Trigger Problem

[45B30]

After playing all day i took my Angle G7 Fly apart to clean. when i took off the Trigger mech, i inadvertantly sqeezed the trigger into the OPTO board and it got 'stuck'. when i pulled the trigger back, there was a horrible grinding twang and now, the OPTO board will not register a trigger pull. i can't turn off the eyes, i've gassed it up, put paint in the breech and it still will not register a trigger pull. Can anyone give me an idea of how to correct this quickly?

[freakoutpaintballer]

my guess would be that the part of the trigger that trips the OPTO is not in the OPTO Tunnel. to fix this simply take the trigger frame back off, rotate the trigger so that the part that is supposed to trip the OPTO board is out of the board. rotate it back so that you can still see a little space between the "tripping piece" and the board. stick a small screwdriver on top of the tripping piece and push down. it may feel like the piece is bending, but dont worry. anyways, push down on the piece and rotate the trigger so that the tripping piece goes into the board. you should see two pieces that look like square LED lights that are not lit up. the tripping piece should be between these two pieces, and im guessing the reason that your gun doesnt work is because the tripping piece is on top of the upper LED. note: when i say LED i dont actually mean LED. they are basically vision eyes inside your board. i hope this helps.