some noob question about a preset on G7

[Raven99]

:puzzled: Hi,
I know this is probably a lame question and off the thread, but on my centerflag preset I have the gauge facing down and a safety valve facing up.
Can I change place the valve with the gauge?? I know that I will need air glue for that job... if it's possible to do the change!

Thanks, Raven99

[BAKERmancan]

No you cannot. Your air system will not function. Do not change the position of anything on your tank; burst disks,gauge,anything.

In that statement I am assuming that when you say "safety valve" you are refering to the fill nipple.

[tgallo]

In that statement I am assuming that when you say "safety valve" you are refering to the fill nipple.

He could be talking about the burst disc. :notsure:

[BAKERmancan]

He may be...but even if he is....he should not move them to another spot...

If you put a burst disk in the wrong spot (i.e. putting the 7.5k disk in the 1.8k spot) it would rupture during the tank fill as soon as it got to 2000 psi.

DONT MOVE ANYTHING ON YOUR TANK

[Raven99]

Hi,
it wasn't the fill nipple, I guess it's the burst disk (I called it safety valve)...
So, I can't change the place of anything. Is there a way to rotate the preset so I can have the pressure gauge face up?

Raven99

[red1]

Just dont turn it all the way i have a on off so i can position the tank where i want it and just screw in the on off and that is it.

[aimedplanet]

I have an on/off as well, but you can't just position the tank and then screw in the on/off. If its sitting too far out you'll get drop off and eventually your marker won't even be aired up. If you have a checkit on/off, they can be rotated to a certain point but nothing huge. Basically what I'm saying is your stuck with your gauge where it is. Deal with it. Mine points down.