big prob. NEED HELP

[lilitalianplaer]

ok so i was installing my lite kit and i thought that everything was working fine. i then unscrew the shim side and screw in my angel gauge. Then it says to dry fire 3 shots and so i did and i heard a big boom and it started to leak. Then i took out my bolt and there was a little ORANGE PIECE
i don’t know what it is and its still leaking
i need to fix this problem and fast
any help you’d be awesome

[warpedx]

Not sure what would cause a bigger boom than the normal dry firing of the gun. Thats the loudest thing i've heard from mine. Where is it leaking? If it's down the barrel, it could be that your valve seal is dead. Remove the valve portion of the lite kit, and check the seal attached to the end of the stem that goes into the valve.

[lilitalianplaer]

it is leaking in the barrel..

[warpedx]

OK, The valve seal is definitely the first thing I'd look at. Don't know that evolve ever used an orange seal, but the stock wdp ones have been orange. Did this happen before you installed the valve portion of your lite kit?

[lilitalianplaer]

i fully installed the lite kit.. (ram) and i also put the exhaust valve.. the on the lpr side i put in my guage. It read around 40 but it says to dry fire it so i help the trigger for 3 sec. turning th eyes of and i heard a boom and air starting leaking.. thats when i looked in the bearch and there was a little orange piece... could it be from the mini reg.. that i did somethign with that

[lilitalianplaer]

or somethng on the LPR side

[warpedx]

It couldn't possibly b from the lpr, and it's highly unlikely that it is from the mini reg.
With it leaking down the barrel, it must be the main valve seal. Have you removed the lite kit to inspect that yet? Make sure that it isn't an orange oring the blew to pieces, that would explain what happened. Is the leak a slow one or a huge rush of air?

[lilitalianplaer]

i was a hudge rush..

[lilitalianplaer]

and do u mean to take out the ram and check that or the exhust side?

[warpedx]

Yes, the exhaust side, but not at the back by the ram. Get into it from the front of the gun, the tube on the bottom left if you're looking straight at it.

[lilitalianplaer]

what should i be looking 4

[warpedx]

Take out the pin that goes into the valve. At the end that goes into the valve, you should see a seal. Take a look at the one you removed to install the evolve kit. It should be somewhat similar, and be in good condition. With it leaking down the barrel, and you finding and orange piece, it might look a little ragged. It will need to be replaced if it is damaged.

[lilitalianplaer]

thanx for the help warpedx.. if i have more ? ill respond.