How to set turns per pull?

[drook]

Hi i have a Arsenal A4 fly with intellifeed Halo b and 3.7 board. I was messing around with some settings and i must have reset everything. The halo used to load a ball per trigger pull now it spins for about 2 seconds. How do i change the software back to only load one ball per pull? Also i cant figure out how to increase the MROF. Sorry iam new to the angel software :get: go easy on me :)

[GMG Force Fly]

Page 7 in your manual. HOPPER T0.05 is for the time and HOPPER A1, A2, A3, & A4 is the number of shots to activate it. The board should stop and intellifeed signal as soon as it sees a ball anyway. Try it with one ball to see.

MROF Press bottom button to change it.

[aimedplanet]

How about changing the balls per second on a Tadao board? My Arsenal G7 Fly is crushing paint because it's spinning too much. Anyone?

[Trigga Nometry]

How about changing the balls per second on a Tadao board? My Arsenal G7 Fly is crushing paint because it's spinning too much. Anyone?What Intellifeed setting on the Tadao are you using?

See this thread too: http://www.angel-owners.com/showthread.php?t=57242

[aimedplanet]

Currently I believe my setting is around 3ish. Mavrick told me it should be around 3.

[Mavrick]

See this link
http://www.angel-owners.com/showpost.php?p=538577&postcount=25

3 is for loader delay. That would be for the amount of time from a trigger pull before the marker board sends a signal to the Intellifeed board. A slight delay to allow the bolt to retract so your not crushing the ball stack from no delay at all.

Read through that thread. Alot of info on what to look for and what other people have found with the Intellifeed and Tadao setup.