F.s.d.o.

[cngham]

I have a 2k3 IR3 I have already searched all the posts I could find on this problem and they all say to adjust the snap ring and lpr. I have installed a new lpr and tried it at preassures fro 75psi all the way up to 115psi. I have adjusted the snar ring multiple times and have tried turning it a full turn in bothe directions in 1/8 turn increments. I still have very bad drop off on the first shot. Once you fire the second and so on it is fine. Any other ideas?:notsure:

[firemedic30]

Make sure that the battery is FULLY charged!!

Also, just give the mini-reg and LPR a good cleaning!

[cngham]

Marker has a predator board upgrade, and has a new 9 volt. I installed a new lps, and greased it, also has a gen X regulator that I removed and tried on another gun.

[firemedic30]

What type of cylinder are you running.....HP or LP?

[cngham]

Hp, Input Pressure Is At About 575 Psi!

[red1]

Raise your dwell.Get in contact with www.tagsportz.com (Bob Sandifer) They sell these boards if i am right they have a setting that is supposed to eleminate this problem.

[blueshifty]

He's right it has to be a setting on the board, because I have one (V3 predator) and it does the same thing. I really don't care because I always shoot a few shots before each game to make sure everything is on and running right. (I think the stting you can change is the one they call stick bolt... I think its like register 9.)