Identity Crisis
05-12-2006, 05:03 PM
Im having some issues with my evolve setup on my 04 speed, ive got the full kit, both the valve, and lpr adjuster, and the lighter hammer, etc...
If i were to completely remove the evolve kit accept the hammer, would the marker be ok? or is the hammer going to be an issue??
2. is the lpr adjuster the main problem with the evolve kits? if so, would i be better off removing it and adjust the lpr the old fashioned way?
Im getting terrible shoot down, and i let someone use it this past weekend for a tournament, its input was at 400 PSI on the minireg, meaning it was suffering from some serious shootdown. I havent been able to cycle paint through it. Heres the set-up, maybe im doing something wrong...
04 flied evolved speed
Tank 450 preset
Minireg, set to just below 250 (thanks to the guage on the a4 flashtank)
Dwell is at 12
Lpr was adjusted to around 104 psi with the reg set to 350 (as stated in the manual)
evolve LPR i believe is around 50 psi
Any ideas?
If i were to completely remove the evolve kit accept the hammer, would the marker be ok? or is the hammer going to be an issue??
2. is the lpr adjuster the main problem with the evolve kits? if so, would i be better off removing it and adjust the lpr the old fashioned way?
Im getting terrible shoot down, and i let someone use it this past weekend for a tournament, its input was at 400 PSI on the minireg, meaning it was suffering from some serious shootdown. I havent been able to cycle paint through it. Heres the set-up, maybe im doing something wrong...
04 flied evolved speed
Tank 450 preset
Minireg, set to just below 250 (thanks to the guage on the a4 flashtank)
Dwell is at 12
Lpr was adjusted to around 104 psi with the reg set to 350 (as stated in the manual)
evolve LPR i believe is around 50 psi
Any ideas?