Is it board or eyes?

[RevBubba]

I have had a problem. I had lazer eyes when I got the Tadao board for my Force Fly...shortly after installing the Tadao..my eyes stopped working. No problem swap my origonal eyes back in and the marker works fine...shoot a couple hundred balls and eyes stop working again.

Is this just really bad luck with eyes...or do I have a board issue?

Any input. I never had this issue before the Tadao...I would take eyes out to clean them before and had zero issues...now 2 sets on eyes in a couple uses.

[KEN CRANE]

i would say the eyes are bad. the board should not cause the eyes to fail. if the eyes were used extencively on the old board that is most likely the cause

[RevBubba]

Thanks Ken...

I have never had eye problems with this marker...maybe it is a fluke...bad set of lazer eyes and then my old eye harness just gave it up at same time.

Also my light is solid blue after the boot up sequence...so it says the eyes are seeing something....it never goes to flashing blue. tha is why I thought it might be the board.

[Michael Prior]

I had the same problem. My eyes are very hard to keep clean with the Tadao board installed. With or without the new lazer eyes the old eyes do the same thing. Try resetting the board after you have cleaned the eyes. Then run some paint with the default settings and see if that will work. It worked for me.

[Michael Prior]

Had the same problem again, called Bob he recomended new eyes. Problem solved.