Setup question...Please help

[bigT86]

I just purchased an IR3 with a a4 board and a4 soft face bolt in it. I have a 68/4500 AA adjustable armaggedon and was just wondering if anyone could give me a rough estimate of what I should set my dwell and tank pressure to in order to get the best performance velocity wise (without ball breaks). I realize some of this depends on the paintballs but overall what are good settings for the a4 board in the Ir3?
Thanks

[Gramps]

Dwell I believe is around 12 and the best pressure to set the tank at is about 400psi. I am not positive about th e a4 settings. But I hope I could help!

[NeoBiCP]

Yes about 12 but i would say 600 psi, because my xp is that 400 is to litle

[Pyrosrule2]

yea ir3 are hp so atleast 600 psi

[Identity Crisis]

the board doesnt determine the dwell setting the gun needs, the guns setup requirea a specific dwell, and the board just makes sure it uses that dwell setting when firing, im in the process of lookin for that answer myself, i dont know, the manual didn't say it when i looked, although i didnt look too hard.

and the tank output should be a minimum of 600 psi or so.