Several IR3 board questions

[punkncat]

I recently got what I thought was an A4 board but is apparently an IR3 board. I noticed that according to the manual the IR3 uses a 6V battery and the Speed which I put the board in uses the 4.8V battery. The board powers up but is acting a bit strangely on the display. Is this due to the lower voltage or a bad LCD screen?

Other than the bad display as far as I can tell the board appears to be working. I haven't been able to tell if it will get the same # of shots per charge....anyway.

This board says Mem2 when I power it up. Is it possible to have this board flashed/ updated? If so to what version and features?

Where can I purchase a Link Cable to be able to unlock the user programmable features? and what do these entail?

Also this IR3 board has a microswitch instead of the Opto switch. Everything I read indicates it should have the opto switch, but the menus are as outlined for the IR3....????

[NeoBiCP]

Well if yo still has your old board then you can take the display off and tjek if its that there is wrong.

about the menu then there isnt the big difrents between the A4 and the ir3 boards menus.

i dont really see what you mean about the micro switch can you try to explayn what it looks like?

[red1]

Some IR3s had micro swiches the earlier ones did also mem2 is the oldest version.Thier will be no unlocking features it is a semi board only.