Evolve kit troubles - 04 Speed

[bsearcy]

Ok so I put in an Evolve Angel Valve Kit in my 04 Speed. I've got everything back together, gas up my marker and have a major leak under my breech block. I put the old parts back in and the leak went away. Anyone know how to get the Newton Valve set up right to where it will seat right and not leak? Thanks.

[Luzrd]

im not completely familiar with the evolve, but it sounds like a valve leak. check to see that the valvestem is seating properly, and the spring is holding it to the valve.
maybe a mod will move this to the evolve section, i think you might get better responses there.

[Th3bLaCkNiGhT]

i had this problem! ... first off ... u may want to post this in the evolve forum if my solution doesnt work ...

ok... the leak is from the valve. the cup seal is not seating well or there is not enough pressure on it. screw in the adjuster scerw on the evolve volly a little bit and then shoot a few shots to see if the leak stops. then from there u can set ur pressures and ur velocity and fine tune everything. if it still isnt working then try upping ur minireg pressure to about 300 and keep ur lpr pressure toa bout 55 ... then it should take its seat and then after a few shots have gun thru it u can lower the lpr and lower the minireg (a lil) and then adjust the evolve volly.

good luck and this should work (just did it again to another one today)