Problem with an Angel 01 C+C

[St.Bjørnar]

Have an Angel 03 C+C and while playing it turns itself off and back on again. What is wrong? I think it's the board, but I'm not sure.

[2k1DarkLCD]

You could possibly have a bad wire connection, between your battery and your board.

Check all your connections, and make sure the battery doesn't rattle in its compartment. If it does, I reccomend you put a paper towel, or something in it to make it fit tighter, to keep it from rattling, because it will cause wires to be knocked loose.

If this doesn't work, you might possibly have a bad board, and you will need to get a board swap. Find more information about a board swap at www.angelparts.com I think it is 25$ for a brand new one. You send yours in, they send you a brand new one.

If you need anything further, don't hesitate to private message me.

[SkeL]

At angelparts.com, they don't send you the board. I believe you pay for the service, send them your marker, and they exchange the board for you so you don't damage your marker.

I suggest you give your marker a full charge and check all your wires. What kind of playing conditions were you in?? Were you getting any Fault errors?

[2k1DarkLCD]

You just send in your board, they will send you back a new one. They make you send in yours, to look over it, and make sure there is no physical damage, only electrical....... and they make sure yours is fried........

[St.Bjørnar]

I was playing indoors and I did give it a full charge before I played.

[2k1DarkLCD]

Did you check all your wire connections yet?

[SkeL]

Give angelparts.com a call, I think they might want you to send your gun in to them to do the swap.