PDA

View Full Version : Oh my a leak right out of the box

Gas Man
02-11-2006, 02:44 AM
well I read my manual front to back befor I even tryed to gas up my new G7 fly.

well I gased it and the macros sealed and I put my ear to the grip..no leak there and then was looking at the laser eye...low and behold I heard a leak coming through the feed neck

So I remember in the manual in the back reading about leak problems..so I narrow it down to either an exahust valve stem guid or the ram.

So I open the breech lock lever and open the breech...hmm no leak.
so I closed the breech and closed the breech lever...damn leak is back.

so I reopen the breech and no leak so instead of repeat the close breech close leaver I just left the breech open and closed the lever and I noticed the ram moves up just a tad and thats were it is leaking from.

o I have to remove the whole ram assembly or is there another way to try and make the ram seal.

according to the manual I have to regrease the ram befor reinserting it and I dont have the recomended grease(Love juice extremegrease).

any suggestions would be welcome

Gas Man
Presto333
02-11-2006, 03:56 AM
hmm, it might just be the valve stuck open a little from the factory? did you try shooting the gun at all?
uniquenewyork15
02-11-2006, 08:07 AM
try dryfiring with your velocity way up
Bigal1
02-11-2006, 09:25 AM
I agree. Don't worry so much if it's leaking right now. If it's a small leak, live with it for a while. shoot a few cases through the marker and see if it changes or goes away.

If you do end up taking it apart, you don't need angel grease. If you're like me, it's hard to find at your local store. tell the store owner you want a good grease with no petroleum in it and use it.
Gas Man
02-11-2006, 10:59 AM
yes I shot mybe 15 paintballs through the marker and its still leaking.

so I will turn up the velacity and run a hopper of paint through it and see if that helps any.
Gas Man
02-11-2006, 03:14 PM
well I ran 2 hoppers of paint through the gun and its still leaking.

went out and bought some evil pus,they didnt have any dow 33 or angel exteme grease,also bought an o ring kit but dont know if they wil fit,there for a irc a4 and speed

well wish me luck,but I just might send it to Angelforce for warranty work,since I did the warranty registration on line

Gas Man
Presto333
02-11-2006, 10:53 PM
well I ran 2 hoppers of paint through the gun and its still leaking.

went out and bought some evil pus,they didnt have any dow 33 or angel exteme grease,also bought an o ring kit but dont know if they wil fit,there for a irc a4 and speed

well wish me luck,but I just might send it to Angelforce for warranty work,since I did the warranty registration on line

Gas Man

ya that would be your best bet, if it's still under warranty might as well use it.
Gas Man
02-12-2006, 12:08 PM
well I pulled out the ram and inspected all the o rings,the o rings look good no rips tears or broken rings,so I wiped all the old grease off and regreased the ram and reinstalled all directions by the manual

Still leaking,so I guess I have no choice but to send it to the MT unless some one here has any ideas


Gas Man
Gas Man
02-12-2006, 07:23 PM
Mr.Frazer help me out.WDP techs are the best

Thank Mr.Frazer!!