Noid or ram problem?

[cb_neosythe]

Alright i have problem with my G7. When i air it up the Bolt flings forward and i have to use my finger to hold it back than it makes a seal and stays back. And my bolt is already in the back position when i air it up i don't keep the bolt for ward cuzz i don't want the detents to wear out or w/e. But also i'm not getting good effiency and there is a very small hissing/leaking/kinda bubbling noise inside the gun. It's near the Noid and it's really minute but i wondered if there is something wrong with the noid and ram. Also the gun says i need full service and valve work, is it my valve as well? and i can't get my back plate off to clean the ram and right side chamber to relube it.

[paintreliever]

drop some oil in the macro, turn air on, shoot aboput 200 or so
take bolt out, and wipe down
and i would check your poppit, just in case

[warpedx]

Frazer made a post about the G7 ram haning around halfway when you first air it up, if it was at a halfway point where the pressure could balance itself strange.
This happened to me yesterday when i aired up the gun. I simply shoved the bolt back, and aired it up quickly, no problems.
The leak is probably comping from underneath the solenoid. Try cranking down on the screw that's on the cover, I had to put a decent bit of pressure on mine to get it to seal. That screw holds the noid against the gasket on the body. If it still leaks, try pulling the backplate and cover, and relube the gasket. If it still leaks, check the orings on the ram.

[cb_neosythe]

The leak is probably comping from underneath the solenoid. Try cranking down on the screw that's on the cover, I had to put a decent bit of pressure on mine to get it to seal. That screw holds the noid against the gasket on the body. If it still leaks, try pulling the backplate and cover, and relube the gasket. If it still leaks, check the orings on the ram.

in the first part you mean the cover that's on the outside of the gun on top of the body over the little top plate thing? and than how would i go about lubing the gasket without jacking it up. First time with a angel don't wonna §§§§ it up.

[uniquenewyork15]

to take off the backplate:
on the breach lever releaser, rotate it all the way clockwise and unscrew the very small screw on it and take it out. then unscrew the backplate screw. pull the backplate out some and hold the white thing that connects the on/off switch. then unscrew the backplate from that. then you backplate is off

[cb_neosythe]

also now there is another problem. THe noise is coming more out of the feed neck and is a humming slash flowing noise at once it's really weird. It sounds like the chick kinda off the grudge if you know what i mean. but i fire a couple times and than it stops, but than after a while it comes back so now i have no idea what is.

[warpedx]

If it's coming from the feed neck, I'll guess the seal on the valve stem is leaking. You can pull it out and see if it looks damaged. To get it out, unscrew the end cap on the valve side, and remove the stem there. Wipe off the seal, and apply a thin coat of oil to it.

[cb_neosythe]

and that "the grudge" gargling noise? but what i really wonna know is how to pull the ram out and clean that whole side and check the orings. I got the back plate and solinoid checked out everything looks great, just wondering now what.