feed neck?

[scribs]

ya im still very new to the wdp thing so here i go!!!my halo does not fit the stock feed neck...ok maybe it does but i cant get the thing to work...alittle help from you wound be nice thanks.if i need to get a new feed neck then is the ccm no rise a good one.are they easy to install?thanks.......

[RangerJoe]

Ok i was having the same problems of trying to get my halo in there. Wut i did( i herd this tip from trigga) dab a lil bit of grease on the halo feed neck. Rub it around it(only use a lil bit) once you rub it around loosen the feed neck and slowly in a twisting motion insert the halo in.If needed losses the feedenck(on gun) a lil more. Once halo's in tightn up the feedneck and walla your done. ANd bout a new feedenck they are pretty esay to install. I dont have one but im thinking about getting a new feedneck.

[scribs]

so how do you get the old feed neck off?

[RangerJoe]

I belive you have to get a like hairdryer and heat up around bottom of feedneck(there is loc-tite) to break the loc-tite. Then once off put some bule loc-tite on the threads of new feedneck and screw it in.

[scribs]

soulds like a ass pain to me! if i §§§§ it up then there goes my gun..i woulder how much it would cost to get one put on when i send me gun to ken..

[Green4028]

its really nothard at all. Just heat it up a little and use a rubber grip to take it off....

[scribs]

well i geuss back to my main Q....the halo feed neck is to narrow to fit in.the o rings do not touch it..am i just that dum or what haha..

[uniquenewyork15]

just shave downt hte halo feedneck with sandpaper and add a dab of grease and put it in. as far as taking the feedneck off, just twist... and to "install" or twist on a new one, you just twist it on