Help!!

[Ex0DuZ]

hey guys i have a 2k1 dark angel lcd and i just took the back plate off and a spring popped out and i dont know where it goes please help me??????

[warpedx]

That would be the spring that keeps the breech pin in the forward position. This spring goes next to the pin, not around it. If you took the breech pin out, put it back in, then the spring in the hole right next to it, then put the backplate back on.

[crownsk8er]

its hard cause the spring keeps popoin out. i did it too the first night i had mine. it was workin in about 1 min

[Ex0DuZ]

does it go between the pin and the breech knob??? or does it go insde the hole first then put the breech knob in.. also a wire came off. from the ones that connect to the back plate how would i put it back on?the wire is to short to put back on! so i cant put it in is there any way to solve this?

[crownsk8er]

i dont know about the wire but the spring goes in between the pin and back plate.
its a b**ch.

[thog94]

The easiest way to put it back in is to remove the breech knob 1st. This way you can push the spring down with minimal tension on the back plate. The you can put the 2 screws in the backplate. It also helps to have the breech open, that way you can push the rod back up (once the backplate is secure) to put the breech knob back on. It's a piece of cake;)

As far as your wire is concerned, you will need to strip it a little and resolder it back on.