Installed My Tadao (It's A Lil Tight)

[lefty21]

Alright, I finally installed my tadao and although I have'nt shot it with air running through the system, when I pull the trigger there is def a difference between opto and micro....With the tadao the trigger is lil tight, not as free-flowing as the stock board....N E thing I can do to adjust it? Do I have to remove the magnet?

While on the topic of triggers, anybody know where I can get a red, stock g-fly tirgger...Like the one that is on the Dark Angel.....ssswwweeett!!!

[Trigga Nometry]

The first thing you can try is to re-adjust the toe screw setting. Sounds like it might be a little too close to the microswitch.

I removed the magnet from the vernier wheel. What a difference! Light as heck!

[hgroberts]

It takes some getting used to, after a few days of getting used tyo it I was able to shoot faster

[ASP Tech]

With a microswitch, the switch itself will return the trigger (usually not enough to prevent bounce). With a opto switch, only the magnets are returning the trigger. So when you install the microswitch board, you instantly have a little bit heavier pull. Also, make sure the trigger leaf isn't hitting the microswitch at a bad angle.

I'll PM you if Frazer has one of those triggers avail.

[lefty21]

Thanks to all...so remove the magnet and adjust the toe screw...np...And ASP Tech thanks a lot.