Halo B Installation Tecniques on G7 Fly

[Fly-n-High]

Has anyone with this or a similiar combination found a easy way to attach the Halo to the marker? My gun is fairly new and the marker seems to be hard to attach using the stock feedneck.

[uniquenewyork15]

yes! shave down the bottom of the halo a bit with sandpaper. that should do the trick and itll be easy. not to much, jus tso its tight and it isnt too hard to get it.

[Trigga Nometry]

I put a dab of grease on the Halo's neck too, JUST A DAB and it works great. Slides right on there and yet still stays tight.

[DarkCataclysm]

I sanded the feedneck some, It makes it easy to slide in the feedneck and holds tight with no wobble once tightened down.

[Fly-n-High]

Kool thanks for the suggestions, but how much should be sanded and what SP grit do you suggest?

[Smoken]

I used some 100C grit sandpaper. Just sand it for a minute then try to put it in the feedneck. Repeat until the fit you desire is achieved.

[Fly-n-High]

Excellant.
Thanks!

[uniquenewyork15]

yup thats what i did. i also tried some grease like trig said and it works even better.

[Fly-n-High]

Well I sanded the stem 4 ever and it still was not able to be skrewed down... Mr. Grinder started to help the situation also. More sanding to follow!! Oh Joy.....

[Fly-n-High]

Persistance pay off! Got her to fit, just like a XXL Jimmy.....

[angelballer4life]

i put my halo in the feedneck and tightened it down and noticed it was a little sideways, not a biggy, so i tried to straighten it out and the feedneck broke loose from the body, any suggestions other than locktite so that this won't happen again?