Help please...

[Mudo]

Im having trouble w/ my speed 05, when i try to to lower the velocity, the screw can move, i mean i could change the velocity of the gun, but when i chrono it it wont change.. can somebody hlp me? has this happened before?

[firemedic30]

Are you taking 5-6 shots after you adjust the screw??

[darksentient]

is anything wrong with your air tank?

[Mudo]

I tried with two different tanks and shot about a loader of paint...
Has this ever happenned to anybody else?

[Mudo]

might this have anything to do with the volumizer?

[darksentient]

i hope you have a low pressure tank. what is your set-up?

[firemedic30]

Check to see if the screw is actually passing through the mini-reg spool??

Maybe the last time someone looked at it, they shoved that too far up and in?

[warpedx]

Turning the screw raises and lowers a ball bearing, which in turn moves the seat of the reg up and down. If any one of these is stuck in the reg, your pressure will not change. I'd start by taking the reg apart, and seeing if you are able to ger the bearing out. Or maybe it's missing.

[darksentient]

hahah. i like your avatar! lol. family guy rocks!

[Mudo]

Allright, nobody has touched that gun since about two months ago, it was chrono´d. i do have a low pressure tank, setting.. i think its stock, my dad didn´t mess around with the electronics, maybe the dealer here did, i dont know. about the bearings ill check that.. i dont think its missing, that reg has never been opened...

Thanks people...

[warpedx]

My bet is that the bearing is stuck then, probably seized up from sitting around. Don't remove the screw, then force the bearing down, as it can get stuck. loosen the screw, then disassemble the reg. With the piston removed, you should be able to see the reg seat (small circular seal).The bearing is underneath this, and above the screw.

[Mudo]

Thanks, ill check that...