Hopper Mode Range??

[firemedic30]

Do we have a range for the Hopper Mode?? I was horsing around and have a 5 and chopped once with my EVO II z/board. I didn't know if anyone knew yet.

I know that the lower the number the better for the force feds. But does anyone else have a range. 1 to 25 pretty wide. I would figure that the higher numbers would be for the Revves.

But, just don't know?? Anyone?

[firemedic30]

I just emailed Will from Tadao. This is what he suggested...
"Tom,

Generally I would run 1-5 for a Halo, 5-10 for an Evo, and whatever works beyond that for a gravity feed.

The intellifeed setting gives multiples of 20 ms to run the intellifeed signal. A setting of 1 is off, while 2 is 20 ms, 3 is 40 ms, etc. Beware that this line is only a signal that is used to trip a relay. It cannot power the loader.

Take care,

Will"

Also, he included that settings for the intellifeeds!

[KEN CRANE]

guys, sorry for the delay. we have located a relay to work for this application. we are testing them now and later next week we will report on the relay that we chose. please set tight.
__________________