confused

[wdp child]

I have never seen anyone with an intel feed. What does it do, how fast does it make it spin, and do i need anything for it to work like a data link?

[Emmit]

the intellifeed is a cable that runs from your Angel to your Revvy motor. It allows you to run your revvy off of your Angel's battery, and depending on which type of Angel you shoot it determines when the motor spins as well. With an IR3 you can set when it spins and how long it spins too, with an LCD it will only spin when you reach a certain rate of fire (like 3 or 4 bps). One of the major plusses is that you no longer need 9v batteries, and it cuts down that weight, but then on the other hand if your rev goes bad, or you have to switch to something other than an Angel for some reason you have to have a backup that's not intellifed.

[wdp child]

so if i used an intel feed on a 9 volt it would be the same as on a 12 because it runs off the lcd battery? And it doesnt spin when a ball isnt in there....only when i go to 3-4 bps?

[Emmit]

sounds like you've got it...

you have to remove the board, and the eye to use the intellifeed cables, there is a sticky in this section on how to set it up. Read through that.

[wdp child]

So if i dont shoot at 3-4 bps it wont feed? Can i get a data link and make it spin at different times?

[Emmit]

I don't remember the exact bps you have to shoot to make it spin, but on the LCD that's the only way to do it. You can't change the programming on it like you can with the IR3.

[Mr.T]

yep 2bps def.