90 frame

[dirka_dirka]

wat mods would i hav to do to a 90 frame or cobra fierce(ir3-06speed) frame to put it on my lcd

[FATBACK]

You'd have to mill the frame for your board, unless you were using the ir3 board.............

[Punch]

If you don't feel like milling the frame for your board you can always shave a little off your board to fit the frame. I had to file a little off the top right corner of my board to fit it in the 90 frame. There was never any chance of damage to the board because there's no electronics in that part of the board. It's a lot easier to file off a little on the board than it is to mill the frame.

[Shibbykins]

bust out with the dremmel n cut the corner where the top screw goes. pay attention to the leads on the board n u will be fine

[eVoPaNoP]

Sorry to be bringing this thread back from the dead... but, does that mean that a 90* frame from a IR3, or otherwise, would match up with the screw placement on an LCD body? I'd really like to put a 90* frame on my LCD, as I prefer the hand placement much more over the 45*. :cheers:

[Shibbykins]

it matchs perfect. i have a A4 frame on my purple LCD. It works fine