PDA

View Full Version : Need Schematic Of 6 Volt Smc Solenoid~problems!

faceplant44
10-21-2005, 10:50 PM
Hey guys, i really need an official schematic of the 6 volt 03/04 speed smc solenoid. I'm haveing major leakage/whistleing coming from the rear (back of gun) of the solenoid. I need your help to fix this. I could sware i've tried every single combo of things but i guess i haven't so please let me know. BTW i have a tourney this sunday. Thanks for the help.
Paintballjc
10-22-2005, 01:00 AM
Replace the Gaskets. Which you can get at any of the sponsors above.... It could also also be the Ram orings... So, check those out
Chris...
10-22-2005, 02:12 AM
grease, and put new o rings on your ram, its because you have a bad o ring on the ram, be sure to position it right, so its not fing evrything up
faceplant44
10-22-2005, 05:33 PM
no it's coming from the solenoid and i fixed the problem but another has arisen. It ended up being the last o ring on the piston inside the solenoid. Now my problem is this. I gas it up, the hammer goes forward then back really quickly then i shoot it and it gets stuck forward.
Chris...
10-22-2005, 08:50 PM
grease, and put new o rings on your ram, its because you have a bad o ring on the ram, be sure to position it right, so its not fing evrything up

do this, and your problem will go away
Vantage_TeS
10-22-2005, 09:28 PM
no it's coming from the solenoid and i fixed the problem but another has arisen. It ended up being the last o ring on the piston inside the solenoid. Now my problem is this. I gas it up, the hammer goes forward then back really quickly then i shoot it and it gets stuck forward.

I believe that one is supposed to be split if memory serves. There should be a split one on either end. It was a different color is that correct?
faceplant44
10-22-2005, 10:57 PM
do you know what your talking about? It's not the ram assembly idk what your talking about.