04 Speed not Firing when Aired up

[GamingSpartan]

I'm hoping a WDP tech or someone thats had this problem can help.

When I air up my 04 speed nothing leaks, hisses, or explodes. It just airs up regularly. When I turn it on it turns on like normal full battery charge and all. When I pull the trigger the LED bar registers it as a trigger pull and I can hear the solenoid click. But it doesnt fire. Any Ideas on what it could be?
:notsure:
But if no one knows :drink:

[uniquenewyork15]

if you ahve a check it then make sure you turn the valve tight enough..if not that i guess take it to certified shop or the mts

[Luzrd]

was anything done to the gun before this happened? any problems in the past?

remove the minireg and turn the tank on. if air blows through the reg then you know the gun is getting pressure. if not its a tank problem.

if the gun is getting pressure put the reg back on, turn the air on, and use a screwdriver or anything that will fit to push the exhaust valve open to see if there is pressure there.

let us know what you find and we can go from there

[GamingSpartan]

well when it stopped working the bolt chopped a ball and got stuck forward I reset it and it usually oworks but it didnt. So you think I should manually open the exhaust valve? I can even get the mini reg off. And I'm Using a Macdev Conquest not a preset. But thanks Ill give it a try

[speedball4life]

Ummm the sensi rod could be getting pushed down by paint????

[GamingSpartan]

nope thought of that to even if the sensi rod is depressed it would still fire at least one shot every three seconds.

[Exile71x]

Im having the same problem with my 04 speed w/evolve kit. I even had the gauged hooked up to my lpr to check its pressure and it was at 50psi but wouldnt fire. i turned the sensi on and off and tried it with and without paint.

[three fut nuthin]

uh, if your using the conquest adjustable make sure u have 450 PSI + into your marker. To push the valve open, use a Q tip or tooth pic. Good luck