trigger stiff

[BonzaiFNG]

i was wondering if there were any ways to make the trigger lighter because the trigger seems very stiff thanks guys

[big azn]

you can remove the back maggnet, but it could cause extreme bounce unless you adjust your trigger right.

[BonzaiFNG]

alright thanks anyone else have any recemmendations any mts? and how do you take the back magnet out the trigger is oh so stiff :thumbsdow

[BonzaiFNG]

i finally got to shoot the gun with paint today and with ramping the gun shot great but when i switched it to semi the gun was horribly slow because the trigger is so stiff can somebody please help me!!? ive heard aout removing magnets and flipping them around etc.. but can someone clarify it for me

[ThaBo$$]

Try loosening your venier set screws so they are not in contact with the venier wheels, i found on my marker it makes the trigger a lot more responseive.

Hope this helps

[BonzaiFNG]

thanks big boss man anyone else have any suggestions

[BonzaiFNG]

alright i tried loosening the set screws that worked a litle bit but it is way to stiff anyone else have any suggestions

[whitepimp259]

alright i tried loosening the set screws that worked a litle bit but it is way to stiff anyone else have any suggestions

Remove the little o-ring things on the trigger...

[KEN CRANE]

i was wondering if there were any ways to make the trigger lighter because the trigger seems very stiff thanks guys


START BY REMOVING THE REAR MAGNET

[shaq787]

you can replace the wheele with one from an A4 or fly so that its still there as a stop point.

[BonzaiFNG]

Aright so how do i remove the rear magnet just take the wheel out and have nothing there? or is there a way just to remove the magnet and keep the wheel thanks everyone!

[big azn]

Do a SEARCH it will help. You can either just figure out a way to pop the magnet out. Idk get creative, Ive heard of ppl throwing it drilling into the plastic or simpley popping it out with a knife. OR you can just buy a A4 FLY vernie wheel from one of the sponsors up at the top of this site.

[whitepimp259]

Do a SEARCH it will help. You can either just figure out a way to pop the magnet out. Idk get creative, Ive heard of ppl throwing it drilling into the plastic or simpley popping it out with a knife. OR you can just buy a A4 FLY vernie wheel from one of the sponsors up at the top of this site.

I pop'ed mine out with a knife, took a good 5 minutes or so.

[rkhtwo@aol.com]

yuo poped it out with a knife and how does it feel now?

[whitepimp259]

yuo poped it out with a knife and how does it feel now?

Ehh, hows 17+bps sound?

[BonzaiFNG]

thanks everyone my angel sings now