the clicking when you adjust your ram

[SpeedFreak05]

how loud of a clcik should it be...i mean i have it to where i can open and close the breech but the click is kinda loud... what should i do leave it or back it out a tad?

[SpeedFreak05]

well if i could get more ppls answers that would be great.....also does anyones trigger wiggle side to side a little bit?

[Bigal1]

amount of click is up to you. all you're trying to do is make sure that there is no slop between ram movement and hammer movement. If you hear a click when you close the breach, then you know that the two are lined up with no slop in between.

I'd say you don't want a lot of friction when you close the breach. just a little snap and that should be all you need although I don't think more is going to hurt anything just make closing the breach a little harder.

[shaq787]

its best to adjust the ram when the marker is gassed up and if you go too far in degass it and pull the ram out. then start over again. i have a hard click on mine, it takes a conciterable amount of force to open the breach.

[Hep]

Always adjust that with the gun aired up