Toolkit for G7

[Bolle]

Does anyone know when it will be out.

It says in the manual that the pressure from the minireg should be 350psi while setting the LPR pressure. How can I check that its at 350?

I have the old kit but it wont allow me to check that the pressure is 350. And i cant build a reg tester since the g7's minireg would not work with it.

I really think that WDP should sell an update to the toolkit. The update should include atleast:

-Guage that goes upp to about 500.
-Piece that will allow you to test the pressure from the minireg.

[Trigga Nometry]

This is how I modified my tool kit to allow me to measure both the LPR and minireg pressure on the G7 and Speed 05: http://www.angel-owners.com/showpost.php?p=389457&postcount=39

Evolve also makes an Angel Gauge Adapter that you can use to do the same thing, all you'll need is a $5 gauge and you can do it: http://www.evolvepaintball.com/other.php

[Trigga Nometry]

See this too to see it on the G7: http://www.angel-owners.com/showpost.php?p=389820&postcount=52

[Bolle]

Thanks Trigga

I had already seen the pictures of your toolkit and i actually have almost all the pieces to build it. I only need the second gauge and your custom pin holder. I did not know that evolve sold those gauge adapters. Do you know if that adapter works on the G7 with the stock internals or if you need the newton kit in order to use it.

I think that the MT's should sell an adapter that works with the G7. I would buy it.

[Trigga Nometry]

Thanks Trigga

I had already seen the pictures of your toolkit and i actually have almost all the pieces to build it. I only need the second gauge and your custom pin holder. I did not know that evolve sold those gauge adapters. Do you know if that adapter works on the G7 with the stock internals or if you need the newton kit in order to use it.

I think that the MT's should sell an adapter that works with the G7. I would buy it.The gauge adapter will fit on the G7 and does not need the Newton Kit. Like you probably already know, the gauges are pretty darn cheap.

If you need one of those things that you saw, I had a bunch more made. This time I had them made out of steel. Much better! I forgot I had more made. I was debating if I should post them or not in the B/S/T because I doubt there is much demand for them. You could also use a piece of macro line over the valve stem and into that adapter and kinda get the same effect to check your minireg pressure.

http://img.photobucket.com/albums/v154/TriggaNometry/Phallanx/100_0738.jpg

http://img.photobucket.com/albums/v154/TriggaNometry/Phallanx/100_0736.jpg